How Much Does Mold Remediation Cost in Murfreesboro, TN?
If you’ve spotted mold in your home and you’re trying to figure out what it’s going to cost before calling anyone — this is the right page. At Murfreesboro Mold Remediation, we work in Murfreesboro and Rutherford County every week, so these numbers come from real jobs in this area, not national averages pulled from the internet.
The short answer: most homeowners in Murfreesboro pay somewhere between $500 and $6,000, depending on where the mold is and how far it’s spread. A bathroom corner is a completely different job than a crawl space that’s been wet for two years.
How Mold Remediation Is Priced Per Square Foot
Most companies here don’t charge by the hour or by the room. They charge by the square foot of affected area — and the rate changes based on where the mold is and how hard it is to reach.
| Location | Cost Per Sq Ft | Typical Job Total |
|---|---|---|
| Surface mold (tile, concrete) | $10 – $15 | $500 – $1,500 |
| Drywall / inside walls | $15 – $25 | $1,500 – $4,000 |
| Crawl space | $15 – $25 | $1,500 – $4,500 |
| Attic | $15 – $25 | $1,500 – $6,500 |
| HVAC system | Flat rate | $3,000 – $10,000 |
| Black mold (Stachybotrys) | +25–50% premium | Varies |
| Whole home | $10 – $25 | $10,000 – $30,000 |
One thing worth knowing: most contractors won’t come out for less than $500 regardless of job size. Even a 10 square foot patch has a minimum charge — mobilization, containment setup, equipment, and disposal all have to happen whether the affected area is small or large.
Mold Remediation Cost by Location in Your Home
Bathroom mold
Usually the least expensive call. Tile grout, ceiling corners, around the tub — these are surface-level jobs in most cases. One day, no major demo, clean and done. The exception is when moisture has been sitting behind the wall long enough to get into the drywall, which changes the scope completely.
Single room with wall mold
Once mold gets into drywall, that material has to come out — you can’t just clean it. Add drywall replacement on top at $1.50 to $3.50 per square foot. This is the job where homeowners are most often surprised by the final number because the visible patch on the wall is just the surface of a larger problem behind it.
Crawl space mold remediation in Murfreesboro
This is probably the most common serious job we handle in Rutherford County. Older homes in Blackman, Walterhill, Lascassas, and parts of Siegel have crawl spaces that were never properly sealed. Ground moisture comes up, wood joists stay damp, and mold grows for months or years before anyone looks down there. Tight access adds labor cost. Most crawl space jobs also need a vapor barrier after remediation — budget $500 to $1,500 extra for that.
Attic mold removal
Almost always caused by a slow roof leak or inadequate ventilation. Working in an attic in a Tennessee summer is brutal — and that difficulty is reflected in the quote. Insulation usually has to come out. If roof decking is affected, costs move toward the higher end fast.
HVAC mold
The one situation where the cost can genuinely surprise people. When mold gets into ductwork, it’s not a spot job — every duct line has to be cleaned and the air handler treated, because the system has been circulating spores through every room in the house. This is also the mold situation most connected to ongoing allergy and respiratory symptoms that homeowners can’t figure out.
Water damage with mold
Mold starts growing within 24 to 48 hours of materials staying wet. If your home had water damage — a pipe, a storm, a slow leak under the sink — and it wasn’t dried professionally within that window, mold remediation cost typically runs higher than a standard job because multiple materials are usually affected.
What Pushes the Price Higher
A few things consistently move quotes to the top of any range:
Mold behind walls. Accessing wall cavities means cutting drywall, which means demo labor and material replacement costs stack on top of the remediation itself.
Black mold. Stachybotrys — what most people call black mold — requires enhanced containment, full respirator equipment, and third-party clearance testing after the job is done. That’s a legitimate 25 to 50 percent premium over standard mold.
Older homes. Pre-1980 Murfreesboro homes sometimes have both mold and asbestos in the same area. If an asbestos test comes back positive, that’s a separate abatement process with its own cost entirely.
The source wasn’t fixed. This one isn’t about job complexity — it’s about whether the contractor addresses what caused the mold, not just the mold itself. If the drainage problem, roof leak, or ventilation issue stays, the mold comes back in 3 to 6 months. Any honest company will identify and address the moisture source as part of the job.
Does Homeowner’s Insurance Cover Mold in Tennessee?
Sometimes — but the distinction matters. Tennessee homeowner’s insurance typically covers mold remediation only when it resulted from a covered event, like a sudden pipe burst or storm-related water intrusion. Gradual leaks, long-term humidity buildup, and deferred maintenance are almost always excluded.
Most policies also cap mold coverage at $5,000 to $10,000 even if the actual job runs higher. If you’re planning to file a claim, documentation needs to happen before work starts — inspection report, moisture readings, photos. We handle all of that as a standard part of our process.
What Does a Mold Inspection Cost in Murfreesboro?
Before any remediation quote, you need an inspection. In Murfreesboro, professional mold inspection runs $250 to $450 for a standard home. If you need air sampling or lab testing — which is common when mold is suspected behind walls but not visible — add $150 to $400 on top.
We offer free inspections. Call (615) 249-1292, we come out, check moisture levels throughout the home, identify exactly what’s there, and give you a straight quote. No upselling, no pressure, no vague estimate that doubles after demo starts.
